 |
|
|
|
|
|
|
|
|
|
|
Complex Lux S4
The "Complex Lux S4" is a high-luminous density equipment which is suitable both for laboratories and consulting rooms. It has a wide polymerization chamber and an even photopolymerising light, thanks to the arrangement of the 4 lamps. The drawer - container has a safety device which avoids the undesired start of the luminous source if it remains open, it works on a fixed track and remains steady on the equipment. The digital electronic timer placed on the front panel enables to set the polymerisation time according to the user's needs, the end of cycle is marked by alarm. Cod. 00403 |
|
|
Complex Lux S8 The "Complex Lux S8" is a universal -type equipment with 9 lamps. Thanks to the selector it is possible to use all the lamps or the 8 UVA lamps placed alternatively above and on each side of a turntable. At the back, behind a protection glass, a halogen lamp allows the light to act on any part of the prosthesis. The controls are placed on the front panel, it is possible to select the duration of the photopolymerisation cycle. On the rear part, a cooling fan is placed beside the hour counter, to prevent any overheating of resins during the polymerisation stage.
Cod. 00402 |
|
|
A C T I O
Actio is a manual equipment for pressure-injection. The injection stage must be carried out by the operator, the pressure maintenance after injection is guaranteed mechanically by a spring system and the temperature is controlled electronically by a microprocessor. Melting and cooling times must be ensured by the operator thanks to an external timer.
Cod. 00012 KE |
 |
|
J - 100 Evolution
The J-100 and J-200 Evolution are the latest additions to the Injection Moulding Systems range, for the pressure injection of thermoplastics. Both Systems have a microprocessor, which allows you to check the temperature, injection time and the cooling time under pressure.
Advantages:
1. New Melting System 2. Liquid crystal display 3. New System for checking temperature 4. 30 pre-set, modifiable programs 5. Visible programme setting 6. Setting for pre-injection alarm 7. Fan-assisted ventilation 8. Digital pressure reading
Cod. 00010 KE |
 |
|
J
- 200 Evolution
A special machine for large productions. The J-200 Evolution is composed of two completely independent operational Systems.
Cod. 00014 KE |
 |
|
I.C.A.R "Injection conventional acrylic resins"
The I.C.A.R. device is meant for those who use Actio, J100 and J200 evolution Pressing pressure - injection methods. The technology applied allows the use of these devices as injectors for all conventional acrylic resins (powder /liquid). Using the I.C.A.R. accessory it is possible to keep the resin under constant pressure during the polymerisation stage, thereby improving fit, precision, and avoiding any raised bites.
Cod.00014 |
|
|
Muffola tipo 50
Double flask for small details
Cod 00030 |
 |
|
Muffola tipo 100
Universal flask for different types of injection
Cod 00020 |
 |
|
Muffola tipo 200
Big flask for the injection of large works, for example two prostheses.
Cod 00025 |
 |
|
Airham
Air hammer to remove plasters and coatings
Cod. 00201 |
 |
|
Avv.
Very handy pneumatic screwer, specific for muffles, it allows screwing and unscrewing muffle screws always with the same strength.
Cod. AVV-C |
 |
|
. . . . . . . . . .. . . . . . |
